AP® Biology simulator

Enzyme activity and inhibition

See how substrate, temperature, pH and inhibitors speed up or slow down an enzyme.

About this tool

Change the substrate concentration, the temperature, the pH and the inhibitor, and watch the reaction rate. Run trials to collect data points as you would in a lab, then answer the questions below about the same model.

How it works

The rate is the amount of product made per minute. This model makes the following assumptions:

  • Substrate. Rate = Vmax[S] / (Km + [S]) (the Michaelis-Menten equation). At low substrate, more substrate means more collisions with free active sites, so the rate rises steeply. At high substrate nearly every active site is busy, so the rate levels off at Vmax (saturation). Km is the substrate concentration that gives half of Vmax.
  • Temperature. Warmer molecules move faster and collide more often with enough energy, so the rate rises (here it roughly doubles for each 10 °C in the cool range). Above a point the enzyme unfolds (denatures): its active site loses its shape. The model treats unfolding as instant and reversible and multiplies Vmax by the fraction of enzyme still folded. Real denaturation takes time and is often permanent, so a measured best temperature depends on how long the assay runs.
  • pH. pH changes the charges on amino acids in the active site. The model multiplies Vmax by the fraction of enzyme whose active-site groups carry the right charges. In real enzymes pH can also change Km, and extreme pH unfolds the protein.
  • Competitive inhibitor. It resembles the substrate and binds the active site, so substrate and inhibitor compete. Apparent Km = Km(1 + [I]/Ki); Vmax is unchanged, because enough substrate outcompetes the inhibitor.
  • Noncompetitive inhibitor. It binds another site and changes the enzyme’s shape, so enzyme molecules holding it do not work. Apparent Vmax = Vmax / (1 + [I]/Ki); Km is unchanged. Real inhibitors can show a mix of both effects.
  • Runs. Each trial adds random scatter (standard deviation 3% of the rate), like measurement error in a real lab. The curve shows the model without scatter.
  • The three enzymes are models with made-up numbers. Their best temperatures and pH values are typical of the kinds of enzyme they are named after. Ki = 1 mM for both inhibitors.

Notes for this topic: Environmental Impacts on Enzyme Function